2N VoiceBlue MAX v1.5 User Manual

Page 86

Advertising
background image

86

2N TELEKOMUNIKACE a.s., www.2n.cz

®

LCR Table

AT&R – Shows LCR table
AT%R##=net,hh:mm/hh:mm/w,gr* – Settings of line ## (0..63) of LCR
table

net – number of network list (0..8)
hh:mm/hh:mm/w* – line using time limitation
gr – GSM group numbers

Test Calls

AT!SGxx=dial – Initiates testing call from AUX interface (xx is the called
interface):

00..31 – GSM module
32 – to GSM via GSM module according to call prefix

AT!WGxx – Connects the following call from interface xx to AUX interface

00..31 – from GSM No.
32 – first incoming calls from GSM

AT!D – Terminates call on AUX interface

Trace

Trace can be activated for only one session at a time.

AT!RE

Start tracing of error messages on active interface

AT!Lx

Start tracing of LAN & Telnet on layer x

x=2 – Layers IP,TCP,Telnet
x=3 – Layers TCP, Telnet
x=4 – Layer Telnet

AT!Rx – Start tracing of ISDN PRI & GSM on layer x

x=1 – Layers 1,2,3,4
x=2 – Layers 2,3,4
x=3 – Layers 3,4
x=4 – Layer 4

AT!RR – Start tracing (AT!R2) to COM1 interface
AT!RX – Stop tracing (AT!R2) to COM1 interface

SMS Control

SMS control can be activated for only one session at a time.

AT!G=#

A6 – activate control via used session
55 – deactivate control via used session
99 – deactivate control on all sessions

AT^MS=ch – Module status ch=0 – 31
*module: ch,sim,sts3,sts2,phs2,type – Response to AT^MS:

ch – number of wireless engine
sim – number of currently used SIM: 0-none, 1-8-holder 1-8
sts3 – status of layer 3
sts2 – status of layer 2
phs2 – substatus of layer 2
type – type of wireless engine

AT^MI=ch – Module info ch = 0 -31
*minfo: ch,sim,netid,"oper",new,cnt – Response to AT^MI

Advertising