Clip routing table + callback, Mobility extension – 2N VoiceBlue MAX v1.5 User Manual
Page 59
59
routing rule to set the fallback port in the Gateway configuration
.
Port modes
Tariffs – select the tariff group (free minute counter) to be used for the outgoing
call. Refer to the
for more details.
GSM outgoing groups
Ignore tone detection in last group – having detected a user defined tone (refer
to
), the GSM gateway terminates the call and seeks for
GSM basic settings
another call setup option by default. If this parameter is activated, the GSM
gateway ignores the tone detection results and sets up the call if this is the last
call setup option.
CLIP Routing Table + CallBack
The table permanently assigns CLIPs to the extensions to which incoming calls are to
be routed automatically and set the CLIP list for the GMS network for which the
CallBack function is enabled.
GSM number (CLIP) – user identification in a GSM/UMTS network.
AutoDial – enable/disable CLIP routing for the selected CLIP.
Dial to VoIP – enter the VoIP destination number for CLIP routing.
Auto CallBack – enable/disable CallBack for the selected CLIP.
Limit – set the maximum call length (in minutes).
Mobility Extension
The table registers the Mobility Extension users.
Name – enter the user name for calling to VoIP.
User – enter the registration user name for VoIP.
Password – enter the registration user password for VoIP.
GSM number (CLIP) – enter the user SIM card CLIP.
Follow me function – enable/disable call forwarding to a mobile user station
(based on CLIP).
SMS at no answer function – enable/disable sending of information SMS on
missed calls.
Note
You are recommended to read the Routing Algorithm for Outgoing
section on p. before setting the LCR table and prefix lists.
Calls
Remember to set the tariffs correctly in the
sectio
GSM outgoing groups
n to make tariff routing work properly.
The maximum count of LCR table records is 256.
Tip
CallBack detects the CLIP from right to left. Thus, configure 10 rules for all
the incoming CLIPs to make CallBack work properly. Each of the rules
must contain one of the CLIPs: 0,1,2,3,4,5,6,7,8,9.
Note
Remember to activate the CallBack mode in the
GSM incoming groups
window for a proper CallBack function.
The maximum count of CLIP routing table records is 96.