APG MND user manual - Manual (Page 11)

Rev. A1, 5/14 MND
11
Automation Products Group, Inc.
APG...Providing tailored solutions for measurement applications
Tel: 1/888/525-7300 • Fax: 1/435/753-7490 • www.apgsensors.com • [email protected]
OVR-Ld
(Overload): allows the user to set an overload warning if the reading increases
beyond the specifi ed value.
NOTE: when displaying the readings from mul ple sensors, the Overload se ng
will be applied to the readings of all the sensors and cannot be set for each sensor
individually. By default the Overload is set to 99999 so that the overload warning will
only be displayed when a sensor reading is greater than 5-digit limit of the display.
bAT EN
(Ba ery Enabled): allows the user to select either No Ba ery, Internal Ba ery
or RST Ba ery op ons. The Internal Ba ery op on is used to monitor the voltage of a
ba ery powered MND. The RST Ba ery op on is used to monitor the supply voltage of
an RST-5000 module ac ng as the master device.
NOTE: the Internal ba ery indicator is limited to ba ery voltages less than 15 Vdc.
bATFUL
(Ba ery Full Voltage): sets the voltage associated with a full ba ery indica on.
bATLOW
(Ba ery Low Voltage): sets the voltage associated with a low ba ery
indica on.