APG MND user manual - Manual (Page 27)

Rev. A1, 5/14 MND
27
Automation Products Group, Inc.
APG...Providing tailored solutions for measurement applications
Tel: 1/888/525-7300 • Fax: 1/435/753-7490 • www.apgsensors.com • [email protected]
Rese ng the MND to factory defaults
Simultaneously press and hold the Decrease/Power bu on and Enter bu on for
approximately 5 seconds. This will bring up the 3 digit opera ng mode number. Change
the mode number to 125 and press the enter bu on. This will reset all parameter values
to the following factory defaults:
Parameter Value
Units
Gallons
Auto-Off 65535 (disabled)
Decimal Place 0
Digit Mask Off
Digit Shi 0
Mul plier 1.000
Bar Graph 0 0
Bar Graph 100 10000
Over Load 99999 (max display value)
Ba ery Gauge Enable No Ba ery
Ba ery Full 13.5 V
Ba ery Low 11.0 V
Analog Low Reading 0
Analog High Reading 99999
Analog Low Calibra on 0
Analog High Calibra on 16383
T1 Type Off
T1 Reading 1000
T1 Window 500
T2 Type Off
T2 Reading 1000
T2 Window 500
Baud Rate 9600
Parity None
Stop Bits 1
C-Type Master
Sensor Address 1
Number of Sensors 1
Register Number 303
Func on 4
Register Type U32 (unsigned 32-bit)
Scan Rate 000.5 seconds
Sensor Labels Sen 1 - Sen 11
Percent Full 00000 (disabled)