APG MND user manual - Manual (Page 24)

MND Rev. A1, 5/14
24
Automation Products Group, Inc.
APG...Providing tailored solutions for measurement applications
Tel: 1/888/525-7300 • Fax: 1/435/753-7490 • www.apgsensors.com • [email protected]
Step 10: When the programming window opens, the register values should automa -
cally populate (if not, click the “Receive All” bu on at the bo om of the window). To
change a single parameter, simply click on the value you wish to change, enter the
desired value, then click the adjacent “Send” bu on to write the new value to the MND.
Step 11: To change mul ple parameters, individually click on the values
you wish to change, enter the desired values, then click the “Send All”
bu on at the bo om of the window to write all the values to the MND.
A er clicking “Send” or “Send All”,
a green window indicates good
communica on and the value was
successfully wri en to the MND.
A yellow window indicates the value was
not wri en due to either a communica on
failure or the value exceeds the allowable
limits for that parameter.