Units (units of measure label), Entr (enter bu on func on) – APG MND user manual User Manual
Page 9
Rev. A1, 5/14
MND
9
Automation Products Group, Inc.
APG...Providing tailored solutions for measurement applications
Tel: 1/888/525-7300 • Fax: 1/435/753-7490 • www.apgsensors.com • [email protected]
•
UNITS (Units of Measure Label)
Allows the user to select the unit of measure label that will appear on the lower display
line.
Op ons:
CU
FT (Cubic Feet)
LITERS (Liters)
MCU
FT (Million Cubic Feet)
CU IN (Cubic Inches)
GALLON (Gallons)
bARREL (Barrels)
CU
M (Cubic Meters)
PCTFUL (Percent Full)
CUSTOM (Custom Units)
NOTE: the units of measure selected will be applied to all sensor readings and cannot
be set individually for each sensors.
NOTE: the units label will automa cally display PCTFUL (percent full) for any reading
being displayed in Percent Full mode (see page 21 for more informa on).
•
ENTR (Enter Bu on Func on)
Selects the func on of the ENTER bu on when in standard opera ng mode.
Enter
Bu on Func on:
*2RD1F
cycles between 2 readings & temperature in
0
F.
*2RD 1C
cycles between 2 readings & temperature in
0
C.
*2 REAd
cycles between 2 readings.
TEMP F
cycles between the reading and the temperature in
0
F.
TEMP C
cycles between the reading and the temperature in
0
C.
MAXMIN
cycles between the present reading and the highest and
lowest
readings.
*2nd reading is applicable to MP dual-fl oat sensors only.