Atop Technology EH7510 User manual - Manual (Page 105)

Atop Industrial Managed Ethernet Switch
EH7510
User Manual V 1.0
99
3.4.2 Spanning Tree Setup using Serial Console
This section shows how users can see spanning tree information and make changes using
command. Detailed explanations of each technical term can be found in Chapter 2 of this
manual.
Table 3.3
Command Description
[no] spanning-tree Enable/disable spanning-tree.
Spanning-tree forward-dalay<11~30>
Set the amount of forward delay in seconds.
Ex: spanning-tree forward-delay 20: set forward
delay time to be 20 seconds.
Spanning-tree hello-time<1~10> Set hello time in seconds.
Spanning-tree maximum-age<6~40> Set spanning tree maximum age in seconds.
Spanning-tree priority<0~61440> Set spanning tree bridge priority.
Spanning-tree port path-cost <0 ~
2E8><port #>
Set path cost to specific port.
Spanning-tree port priority <0 ~
240><port #>
Set priority to specific port.
Show spanning-tree Show spanning-tree information.
Show spanning-tree port <port #> Show port information.
[no] spanning-tree debug Enable or disable spanning tree debugging.
Spanning-tree protocol-version
<stp/retp>
Choose protocol version.
A detailed description of stp/rstp can be found in
section Spanning Tree of chapter 2
[no] spanning-tree port mcheck <port#>
Force the port to transmit RST BPDU.
[no] spanning-tree port edge-port <port
#>
Set the port to be edge connection.
[no] spanning-tree port non-stp <port#>
Enable or disable spanning tree protocol on this
port.
[no] spanning-tree port point-to-point-
mac <auto | true | false> <port #>
Set the port to be point to point connection.
Auto: specifies point to point link auto detection.
True: set the point to point link to true.
False: set the link to false.