Atop Technology EH7510 User manual - Manual (Page 77)

Atop Industrial Managed Ethernet Switch
EH7510
User Manual V 1.0
71
Table 2.47
EH7510 C EH7510 D
RAPS VLAN 8 RAPS VLAN 8
ERPS RAPS Enabled ERPS RAPS Enabled
West Port 1 West Port 1
East Port 2 East Port 2
RPL Owner Disabled RPL Owner Disabled
RPL Port none RPL Port none
2.13.2.1 UERPS Settings (optional)
1. Prepare two EH7510 (EH7510 A and EH7510 B). We will use Port 7 and Port 8 on both
EH7510 for redundancy.
2. Connect EH7510 A and EH7510 B to the network or PC so you can access them. For
simplicity you can use Port 1 for Web configuration on both switches.
3. Open SwitchView (Management Utility) and change the IP of EH7510 B or both
switches, so the IP won’t be conflicting.
4. Open EH7510 A and B’s WebUI and setup ERPS settings like the following. You just
need to enable ERPS, Log, and UERPS. You need to press “Update” for the changes to
take effect.
Fig. 2.60