Atop Technology SW550XC User manual - Manual (Page 110)

Industrial Wireless Serial Device Server Series
SW550xC User Manual V 1.0
105
6.5 Serial/IP Advanced Settings
In the Serial/IP Control Panel, Click on the Advanced button to open Advanced Settings
window (Figure 6.18). Click on Use Default Settings to load the default settings.
 Extend Server Connection Maintains the TCP connection for specified amount of time
after COM port is closed
 Attempt Server Connection Terminates pending connection attempts if they do not
succeed in the specified time
 Synchronize with Server Upon COM Port Open Required by NT Systems (2000, XP,
Vista, 7)
 Update Routing Table Upon COM Port Open Maintains IP route to a server in a
different subnet by modifying the IP routing table
 Enable Nagle Algorithm Provides better network efficiency by imposing a minor latency
on the data stream while it waits to fill network packets
 Always Limit Data Rate to COM Port Baud Rate Limits the data rate to the baud rate
that is in effect for the virtual COM port
 Attempt Server Connection If credential is set to Windows Credentials, VCOM
automatically adds the current Windows domain to the username
 COM Port Control Keep-Alive Controls the interval at which VCOM will issue the
keep-alive message, if no there is no activity
 Maximum Connection Recovery Interval Controls the maximum time for “Restore
Failed Connection”
 Enable SETXON/SETXOFF COM Port Commands This option enables additional
negotiation on SETXO N and SETXOFF commands and is only available for the “V”
series serial device servers. If the application requires SETXON/SETXOFF feature,
please contact Atop Tech Support.