Atop Technology SW550XC User manual - Manual (Page 61)

Industrial Wireless Serial Device Server Series
SW550xC User Manual V 1.0
56
5.1.2 Link Mode: Configure SW550xC as a TCP Client
SW550xC Series can be configured as a TCP client in TCP/IP Network to establish a
connection with a TCP server in the host computer. After the connection is established, data
can be transmitted between a serial device and a host computer in both directions; this also
applies to Virtual COM running in the client mode.
Figure 5.5
Figure 5.6
By selecting the TCP Client mode, it means that a TCP Server program should be prepared to
connect to SW550xC. Figure 5.6 shows all the settings provided for the TCP Client.
 Click on the “COM1” link on the left hand side.