Atop Technology SW550XC User manual - Manual (Page 16)

Industrial Wireless Serial Device Server Series
SW550xC User Manual V 1.0
11
3.3.2 Terminal Block
Table 3.5
Pin#
RS-232
Full Duplex
4-W RS-422/RS-485
Half Duplex
2-W RS-485
Half Duplex
1
SG SG SG
2
RTS R- DATA-
3
TxD R+ DATA+
4
CTS T- N/A
5
RxD T+ N/A
3.4 First Time Installation
Before installing the device, please adhere to all safety procedures described below, Atop will
not be held liable for any damages to property or personal injuries resulting from the
installation or overall use of the device. Do not attempt to manipulate the product in any
way if unsure of the steps described here
2
, in such cases please contact your dealer
immediately.
1 Prepare the necessary cables, DC adapter, power cord, LAN cable, serial cable, etc.; do
not connect the unit yet.
2 Install the antennas to the SMA connectors.
3 Proceed then to plug the power source to the unit, starting from the ground and then the
terminal block.
4 Place the device in the desired location and connect it to the LAN via an Ethernet cable
with an RJ45 connector.
5 Connect your computer to the LAN network. Default configurations will be addressed
later on Sec. 2.5 .
NOTE: remember to please consult your Hardware Installation Guide when attempting an
installation. Also, please follow all safe procedures when doing so.