Atop Technology SW550XC User manual - Manual (Page 62)

Industrial Wireless Serial Device Server Series
SW550xC User Manual V 1.0
57
Figure 5.7
 Select TCP Client in the Link modes.
 Only two communication modes are available here: RAW and Virtual COM which
definitions are the same as above in Sec. 5.1.1
 Enter the preferred Destination IP and Port. This should match the IP settings of the
TCP Server program.
 Enable and enter Destination IP 2 and Port 2 if necessary. Two different servers can
be set here (for redundancy), the second server has to be enabled by ticking the box.
 Go to Response Behavior for more information on this setting. For serial settings, go
to Sec. 4.6.2 . For Advanced settings, go to Sec. 4.6.3
 Scroll to the bottom of the page and click on “Save & Apply” button to save the
changes.