Atop Technology SW550XC User manual - Manual (Page 45)

Industrial Wireless Serial Device Server Series
SW550xC User Manual V 1.0
40
4.8 E-mail Settings
In case the device raises an alert and/or warning message, it will send an email to the
administrator’s mailbox. Email Settings allows you to set up the device to be able to send an
email. To set up the email sending, you need to put a “Sender” email address which will be
the “From” on the email. Then, you fill in “Receiver” email address to which the email is sent.
You can send the email to several recipients using Semicolon (;) to separate each email
address. Next step is to set the Email Server. First, you fill in the IP address of a Mail Server
in your local network. If the Mail Server needs a user authentication, you need to enable
“SMTP server authentication required”, and fill in Username and Password. Please
contact your network administrator for Mail Server IP address and the Username and
Password, Figure 4.21 . You can click on “Send Test Mail” to verify your mail settings.
Figure 4.21
Attention
It is also important to setup Default Gateway and DNS Servers in the Network Settings
properly, so your SW550xC can lookup DNS names and route the mails to the proper default
gateway.