Atop Technology SW550XC User manual - Manual (Page 35)

Industrial Wireless Serial Device Server Series
SW550xC User Manual V 1.0
30
limited to 54Mbps.
 WEP Key: Enable when Authentication is set to OPEN and Encryption is set to WEP. Up
to 4 different hexadecimal or ASCII keys can be entered in this section.
 WPA-PSK/WPA2-PSK Passphrase: Enable when Authentication is set to WPA-PSK or
WPA2-PSK. It can be between 8 and 63 characters long.
 WPA2 (with RADIUS): Depending on the Authentication Mode selected, different fields
would be enabled. WPA2 (PEAP) would require you to provide the user, password, and
the certificates. WPA2 (EAP-TLS) would require you to provide the certificates and
private key password. WPA2 (EAP-TTLS) would require you to provide the user,
password, and the certificates. Please note that only *.pem certificates are supported.
Please remember that 2.4 GHz frequency is easily interfered by other devices that operate in
the same region (namely, Bluetooth, Zigbee, Microwave, etc.).
Steps to Connect to an Access Point
Input the SSID of the connecting Access Point or you can use the “Scan network” to have
SW550xC grab the necessary wireless information of surrounding access points in the
device’s coverage area, please be patient as this process might take as long as 10 seconds.
Once it has finished scanning, names and basic properties of available networks will be shown
as in Figure 4.14. After this, you can now select an AP from the list and its settings would load
automatically to the device’s UI.
Figure 4.14
If no wireless networks have been found as shown in Figure 4.15.