CHAMPION 54 DR Series-90DRHDPW Manual - Manual (Page 10)

2
Installation
Table Connections
1. Dish tables must be fitted to the dishwasher and their flanges sealed with silicon sealant to
prevent leaks.
2. Install the dishwasher in its final location making sure it is level. Standard table height is
34"/864mm so the dishwasher flange should be set to this approximate height.
3. Adjust the table heights on the load and unload ends of the
machine.
4. The unload (clean end) table should slope toward the
dishwasher so water will drain back into the machine.
5. The load (soiled end) table should slope away from the
dishwasher so soiled water does not flow into the
machine.
Standard Table
Height
34" L-R Direction Shown
Dishwasher
Flange
Table
Flange
Typical table installation with flange sealing detailed view.
21-3/8"
~6"
~30"
Typical table construction
Plan View