CHAMPION 54 DR Series-90DRHDPW Manual User Manual
Page 167
159
1.
Power and Pause LEDs are on.
2.
Drive Jam Switch is closed (NC) LED is on.
3.
Table Limit Switch is closed (NC) LED is on.
4.
Final Rinse Trip Switch is closed (NC) LED is on.
(no dish rack is present)
5.
Rack Trip Switch is closed (NC) LED is on.
(no dish rack is present)
The rack switch starts the pumps and drive.
6.
For Single Tank w/DR, no Prewash:
Final Rinse and wash fill LEDs are on.
Machine fills through final finse and wash
fill valve.
For Single Tank w/DR and Prewash:
Final Rinse, wash and prewash LEDs are on.
For Two Tank without Prewash:
Final Rinse, wash fill LEDs are on. Machine fills
through final rinse,and wash fill valves.
For Two Tank with Prewash:
Final rinse, wash fill and prewash fill LEDs are on.
Machine fills through final rinse,wash and prewash
fill valves.
7.
The RUN LED only indicates that the circuit board
is energized. It does not indicate that the machine
is running.
Note:
Jumper settings must be set for the machine model. Refer to page 157 for all possible machine jumper configurations.
Current State 1: Dishwasher power switch is on. Machine filling for first time.