CHAMPION 54 DR Series-90DRHDPW Manual - Manual (Page 175)

167
1.
Power and Pause LEDs are on. Drive Jam Switch is closed (NC) LED is on. Table Limit Switch is closed (NC) LED is on. Final Rinse Trip Switch is closed (NC) LED is on. Rack Trip Switch is closed (NC) LED is on. (no rack present) Run Light LED is on. Green light on front of control panel is on. The Pumps LED is on.
2.
Under normal operating conditions, the lower and upper floats are up and the LEDs are on.
3.
The Pumps LED is on. (All pumps and drive are running.)
5.
The Heat LEDs are on and circuits enabled. (Tank heaters will be energized if thermostats are calling for heat.)
6.
If the water level falls in a tank and the upper float drops, the associated Flt U LED will go out. (Heat circuit for the tank remains enabled.)
7.
If the water level in a tank continues to fall and the lower float drops, the associated Flt L LED will go out.
(Heat circuit for the tank is disabled.)
8.
The Pumps LED remains on. (All pumps and drive continue to run.)
9.
The associated Fill LED comes on; the fill valve(s) will energize and the tank(s) will fill with water. The FLT L LED and
FLT U LED for each tank will
come on as the tank fills.
NOTE: If the machine fills for more than 20 minutes, the machine will shut down and the Run Light LED will begin flashing. Ch
eck drain
s etc. then turn the machine
Power Switch off and back on to reset the machine. Current State 7: FLOAT SWITCH OPERATION Dishwasher power switch is on. Machine is full of water. Machine is washing.