CHAMPION 54 DR Series-90DRHDPW Manual - Manual (Page 170)

162
1.
Power and Pause LEDs are on
Drive Jam Switch is closed (NC) LED is on.
Table Limit Switch is closed (NC) LED is on.
Final Rinse Trip Switch is closed (NC) LED is on.
Rack Trip Switch is closed (NC) LED is on.
(no rack present)
Run Light LED is on.
Green light on front of control panel is on.
The Pumps LED is on. 2.
The dish rack moving through the machine trips
the final rinse trip switch. The RED Final Rinse
INPUT LED goes out. 3.
The GREEN Final Rinse OUTPUT LED comes on.
(Final rinse valve energizes.) 4.
The Rinse Aid LED comes on.
(120 VAC rinse aid signal is applied to the rinse
aid chemical connection terminal.) 5.
DR Pump LED comes on.
(The DR pump runs.) 6.
The Digital Display Rinse LED goes off.
(The final rinse temperature gauge on the
front of the control cabinet displays the final rinse
water temperature.) 7.
When the dish rack moves off the Final Rinse Trip Switch, the Final Rinse switch LED comes on, the Final Rinse valve
LED goes out,
the Rinse Aid LED goes out, the DR Pump LED goes out, and the Digital Display Rinse LED comes on.
(The final rinse solenoid valve de-energizes,
the 120VAC Rinse Aid Chemical Signal is removed, and the final rinse temperature gauge display returns to “OFF”. Current State 3: Dishwasher power switch is on. Machine is full of water. Machine is washing.