CHAMPION 54 DR Series-90DRHDPW Manual User Manual
Page 172
164
1.
Power and Pause LEDs are on.
Drive Jam Switch is closed (NC) LED is on.
Table Limit Switch is closed (NC) LED is on.
Final Rinse Trip Switch is closed (NC) LED is on.
Rack Trip Switch is closed (NC) LED is on.
(no rack present)
Run Light LED is on.
Green light on front of control panel is on.
The Pumps LED is on.
2.
The rack conveyor, drive motor or
(rack advance table if equipped) jams.
The (NC) Jam switch opens and
The Jam Switch LED goes out.
3.
The Run Light LED goes out.
4.
The Pumps LED goes out.
5.
Heat LEDs remain on.
(Heating circuits continue to operate normally.)
6.
Identify and correct the jam condition.
The Jam Switch LED comes on.
(The most common problem is a ware caught
in the rack conveyor assembly.)
NOTE:
To restart the wash cycle, press the Start button and
insert a dish rack into the machine to activate the
Rack Trip Switch.
The Start LED comes on and then goes out,
the Run Light LED comes on, the Pumps LED comes on.
The machine begins another 90 second cycle.
Current State 4: JAM SWITCH OPERATION
Dishwasher power switch is on.
Machine is full of water.
Machine is washing.