CHAMPION 54 DR Series-90DRHDPW Manual User Manual
Page 173
165
1.
Power and Pause LEDs are on.
Drive Jam Switch is closed (NC) LED is on.
Table Limit Switch is closed (NC) LED is on.
Final Rinse Trip Switch is closed (NC) LED is on.
Rack Trip Switch is closed (NC) LED is on.
(no rack present)
Run Light LED is on.
Green light on front of control panel is on.
The Pumps LED is on.
2.
A dish rack activates the table limit switch located
on the end of the clean-end dish table.
The (NC) TLS Switch opens.
The Table Limit LED goes out.
3.
The Run Light LED is on.
(Pumps and drive stop.)
4.
The Pumps LED is off.
5.
The 90 second timer pauses.
6.
The TLS is deactivated when dish rack is removed.
The Table Limit LED comes on.
7.
The Pumps LED comes on.
(Pumps and drive run.)
8.
The 90 second timer resumes where it left off.
9.
Heat LEDs remained on during TLS operation.
(Heating circuits continued to operate normally.)
Current State 5: TABLE LIMIT SWITCH
(TLS
) OPERATION
Dishwasher power switch is on. Machine is full of water. Machine is washing.