CHAMPION 54 DR Series-90DRHDPW Manual User Manual
Page 171
163
1.
Power and Pause LEDs are on.
Drive Jam Switch is closed (NC) LED is on.
Table Limit Switch is closed (NC) LED is on.
Final Rinse Trip Switch is closed (NC) LED is on.
Rack Trip Switch is closed (NC) LED is on.
(no rack present)
Run Light LED is on.
Green light on front of control panel is on.
The Pumps LED is on.
2.
Stop Switch is pressed. The Stop LED comes on
and goes out when the stop switch is released.
3.
The Run Light LED goes out.
4.
The Pumps LED goes out.
(The pumps and drive stop.)
5.
Heat LEDs remain on.
(Heating circuits continue to operate normally.)
NOTE:
To restart the wash cycle, press the Start button and insert a dish rack into the machine to activate the Rack Trip Switch.
The Start LED comes on and then goes out, the Run Light LED comes on, the Pumps LED comes on. The machine begins another 90 second cycle.
Current State 3 (continue
d):
Dishwasher power switch is on. Machine is full of water. Machine is washing.