CHAMPION 54 DR Series-90DRHDPW Manual User Manual
Page 169
161
1.
Power and Pause LEDs are on.
Drive Jam Switch is closed (NC) LED is on.
Table Limit Switch is closed (NC) LED is on.
Final Rinse Trip Switch is closed (NC) LED is on.
2.
Rack Trip Switch is closed (NC) LED is on.
(no rack present)
3.
When the green START switch on the front of the
control panel is pressed, the Start LED will come
on briefly and then go out.
4.
At the same time, the Run Light LED will come on
and the green light on the front of the control
panel will come on.
(Machine is ready to wash dishes.)
5.
Inserting a rack of soiled ware into the machine
operates the Rack Trip Switch and the Rack Switch
LED goes out.
(The pumps and drive run.)
6.
When the dish rack clears the Rack Trip Switch
the Rack Switch LED comes back on.
7. The Pumps LED comes on.
8.
The 90 second wash cycle timer counts down.
9.
The Digital Display Rinse LED is on and the final
rinse temperature gauge on the front of the control
cabinet reads “OFF”. This is a normal condition
indicating that the final rinse trip switch has not
NOTE: EACH ADDITIONAL DISH RACK ENTERING THE MACHINE RESETS THE TIMER.
been operated by a dish rack.
Current State 2: Dishwasher power switch is on. Machine full of water.
When the pumps star
t,
an upper float in a tank may drop causing an
Flt U LED to go out.
This is a normal
condition.