ETC Echo Architectural Control Processor (ACP) v1.0.0 - Manual (Page 51)

3
Programming 46
Step 1: Scroll to “Activate” or “Deactivate” and press enter ( ) to change the currently
selected Preset state.
•
Selecting to “Activate” a Preset in a Space automatically deactivates any
other Preset that is currently active in the Space. Only one Preset can be
active at a time in each Space.
• Selecting to “Deactivate” a Preset in a Space deactivates the currently
selected Preset in the selected Space.
Record (snapshot) a Preset
Record (snapshot) the current selected Preset using the current levels of all of the circuits
within the selected Space. Levels can be DMX, sACN, manually set levels from the user
interface, or a combination of sources regardless of priority.
Step 1: Scroll to “Record” and press enter ( ).
Set the Preset Fade Time
Fade time determines the length of time it will take for a Preset to fade up or down. By
default, Presets are activated and deactivated using a 2 second fade time.
Step 1: Scroll to “Fade Time” and press enter ( ). The selection changes to the min
field.
Step 2: Scroll or use numeric entry to specify a minutes selection (0-60 min available for
selection), then press enter (
). The selection changes to the sec field.
Step 3: Scroll or use numeric entry to specify a seconds selection (0-59 sec available for
selection), then press enter (
). The selected Preset will fade up and down
using the new specified Fade Time selection.
Sequences
Scroll to select “Sequences” from the “Arch Control” menu and press enter ( ). The first
editable option in this menu list is Space. The lowest configured Space displays by default.
This menu selection allows configuration of the pre-configured Spaces only. Reference
Space Setup, page 40 .
Edit the Space number
Step 1: Press enter ( ), the selection changes to the Space number.
Step 2: Using the scroll wheel, scroll through the available pre-configured Spaces for the
Echo ACP. Use of the numeric keypad is allowed, but specification of a Space
that is not already pre-configured will not be allowed. Press enter (
) to accept
the selection.
Sequence State (read only)
A currently active Sequence will display (read-only) on the line directly below. If no
Sequence is active for the selected Space, “No Active Sequence” will display instead.
Sequences
Space 1
Preset 15 Active
Start
Seq Mode:
Single
Edit Step s
The “Sequences” menu provides the tools start and stop a
Sequence, edit the steps of a Sequence, and configure the
sequence mode. The Echo ACP supports one active Sequence
per Space.