Dimmers, Set levels, Presets – ETC Echo Architectural Control Processor (ACP) v1.0.0 User Manual
Page 80: Dimmers set levels presets
75
Echo ACP Configuration Manual
•
DRd rack information which is visible from the front panel of the Echo ACP on the
•
Currently active errors that may exist in the system which are also visible from the
and
. See also
Messages Generated by the Echo ACP
and
Status / Errors Messages Generated by
for a definition of what a displayed error may mean and how
to resolve it.
Dimmers
The “Dimmers” page provides mostly read only information about the current state of all
dimmers/ circuits in the DRd enclosure. You can change a selected dimmer/circuits level
using the level bar or by selecting one of the two available bump buttons for the circuit.
•
Circuit Number / Module Type
•
Assigned Space number
•
Mode
•
Curve
•
Control %
•
Level
•
[Bump Off] and [Bump Full] buttons.
When a level has been changed or set using this web interface, a new button called
[Release All] displays at the top of the page. Click this button to release the manually set
levels.
Set Levels
The “Set Levels” page allows you to set and release levels for any circuit or range of circuits
in the DRd enclosure.
Input level commands into the command window (green rectangle) use the displayed
keypad and/or a connected computer alpha/numeric keyboard. *Click the “Keyboard
Shortcuts” link to display available keyboard shortcuts.
If your configuration is divided into more than one space, use the “Select Space” drop down
to filter the dimmers/circuits.
•
Use the “and” and “thru” to select a range of dimmers/circuits.
•
Use “Release All” to release all currently set levels.
•
Use “Previous” and “Next” to cycle through the successive dimmers/circuits.
•
Use “Clear” to clear the command window of all data entry.
•
When the command line reaches complete syntax, it will be automatically enter an
asterisk “*” at the end of the command line.
Presets
The “Presets” page allows you to record, activate, and deactivate presets. Presets are
directly tied to the selected Space that have been pre configured into the Echo ACP (see
). For more information on Spaces, see