EUCHNER AS-i 3.0 PROFIBUS Gateway with integrated Safety Monitor for 2 AS-i circuits - Manual (Page 121)

AS-i 3.0 PROFIBUS Gateway with integrated Safety Monitor
PROFIBUS DP
Subject to reasonable modifications due to technical advances Id.-No.: 103329 Issue date - 24.10.2008 EUCHNER GmbH + Co. KG 121
Kohlhammerstraße 16 • D-70771 Leinfelden-Echterdingen Tel. +49/711/75 97-0 • Fax. +49/711/753316
Safety Slaves B
Byte
description
1
0x0C header
2
0xAA (circuit 1)/0xAB (circuit 2) type
3
0x00 slot
4
0x00 spec
5
yellow flashing (0 ... 7)
6
yellow flashing (8 ... 15)
7
yellow flashing (16 ... 23)
8
yellow flashing (24 ... 31)
9
red flashing (0 ... 7)
10
red flashing (8 ... 15)
11
red flashing (16 ... 23)
12
red flashing (24 ... 31)
Tab. 11-9.
EC-Flags (high):
Bit 0: peripheral fault
Bit 1 … Bit 3: reserved
Bit 4: ground fault
Bit 5: over-voltage
Bit 6: noise
Bit 7: duplicate address
EC-Flags (low):
Bit 0: configuration error
Bit 1: slave with address 0 detected
Bit 2: Auto address assignment not available
Bit 3: Auto address assignment available
Bit 4: Configuration mode active
Bit 5: not in normal operation
Bit 6: AS-i power failure
Bit 7: AS-i master is offline
Delta list: List of AS-i slaves with configuration error.
1: ConfigError
0: no ConfigError
LPF: List of AS-i slaves with peripheral fault.
1: peripheral fault
0: no peripheral fault