EUCHNER AS-i 3.0 PROFIBUS Gateway with integrated Safety Monitor for 2 AS-i circuits - Manual (Page 51)

AS-i 3.0 PROFIBUS Gateway with integrated Safety Monitor
Electrical connection
Subject to reasonable modifications due to technical advances Id.-No.: 103329 Issue date - 24.10.2008 EUCHNER GmbH + Co. KG 51
Kohlhammerstraße 16 • D-70771 Leinfelden-Echterdingen Tel. +49/711/75 97-0 • Fax. +49/711/753316
7.7.5 Buttons
The buttons are used for the following:
For additional information see:
• Section <Function of the ESC/Service key>
• Section <Replacing a defective safety-configured AS-i slave>
• Section <Operation in advanced display mod>.
Mode/
⇑
Switching between configuration mode and protected operating
mode, and saving the current AS-i configuration as the nominal
configuration.
Set
/⇓
Selecting the address of and assigning an address to a slave.
OK Change to extended mode.
ESC/Service For teaching the code table for a new safe slave, when exactly one
safe slave is being replaced, and for unlocking the Safety Monitor.
This button is also used to exit extended mode.