Input code seq, Safe output ch (channels for the release circuits) – EUCHNER AS-i 3.0 PROFIBUS Gateway with integrated Safety Monitor for 2 AS-i circuits User Manual

Page 76

Advertising
background image

76

Subject to reasonable modifications due to technical advances

Id.-No.: 103329

Issue date - 24.10.2008

EUCHNER GmbH + Co. KG

Kohlhammerstraße 16 • D-70771 Leinfelden-Echterdingen

Tel. +49/711/75 97-0 • Fax. +49/711/753316

AS-i 3.0 PROFIBUS Gateway with integrated Safety Monitor

Operation in advanced display mod

9.5.1.4

INPUT CODE SEQ.

Main Menu || AS-I SAFETY || TEACH CODES|| INPUT CODE SEQ. ||

This menu point allows you to directly enter the code sequence for a particular
AS-i safety slave. If the slave address is already indicated, you can directly enter
the sequence using the keys and then save or discard it.

To continue, enter the PIN and confirm with OK.

In the following menu you select the AS-i circuit.

After selecting the AS-i circuit the safe unit switches to configuration mode.

Then enter the code sequence.

If no error message is displayed, the teach procedure was successfully complet-
ed.

Use OK to save the entries and return to the previous menu. Use ESC to cancel
the procedure.

9.5.2

SAFE OUTPUT CH (channels for the release circuits)

Main Menu || AS-I SAFETY || SAFE OUTPUT CH ||

In this menu you can read off the status of the 16 release circuits.

TEACH CODES
ENTER PIN
0000
OK

AS-I CIRCUIT 1
AS-i CIRCUIT 2

SLAVE ADDR ––
ENTER CODE 1
00000000
ESC OK

SAFE OUTPUT
CHANNELS
CH 1: ON
CH 2: OFF
...
CH 16: OFF

Advertising