Garland MODUKB10000150 INDUCTION BUILT-IN MODULE-LINE GRIDDLE & BRAISING PAN - Manual (Page 18)

Installation RTCSmp Built-In Module-Line Griddle & Braising Pan
18 Part # 4532414 Rev 2 (1/15/14)
• Installation Steps for Griddle Plate or Braising Pan (griddle shown):
IMPORTANT
To protect the induction unit
from water penetration, you
must apply and bond the
silicone adhesive properly to
create a water-tight seal. Before
you begin the installation, it is
very important to use isopropyl
alcohol (minimum 70%) or
equivalent to clean all surfaces
where the silicone adhesive will
be applied.
A. Custom built an installation frame or create a flange on the counter surface. This flange will
prevent grease or liquid from penetrating into the cabinet and the induction unit.
Countertop opening dimensions: 607mm x 648mm [23.9” x 25.51”].
B. Apply silicone sealant to the lower end of the griddle plate and the countertop where the two
surfaces will meet. Then carefully lower the induction unit into the cut-out.
C. To seal the gap between the rim and the counter surface, apply a thin line of silicone completely
around the edge of the griddle plate.
NOTE: We recommend using a food grade silicone for this application.
NOTE: Allow the silicone to cure for at least 48 hours. Do not start up the griddle during this time.
4.5.3.5 Flush Mounting Instructions for Griddle Plate
Dimensions of Mounting Frame—Dual Griddle (measurements in mm and [inch])