Garland MODUKB10000150 INDUCTION BUILT-IN MODULE-LINE GRIDDLE & BRAISING PAN - Manual (Page 23)

Function Test RTCSmp Built-In Module-Line Griddle & Braising Pan
Part # 4532414 Rev 2 (1/15/14) 23
5 Function Test
IMPORTANT
CAUTION
When the unit is in use, the griddle plate/braising
pan is hot. To avoid burn injuries, do not touch the
unit during operation.
• Before carrying out the function test, the user must understand how to operate the unit.
• Remove all objects from the griddle plate/braising pan.
• Ensure the grease collector (custom-made) is installed properly before operating the unit.
To perform a function test:
1. Turn the control knob to set the temperature, for example 392°F (200°C).
2. The display shows the set temperature value.
3. If the set temperature (for example, 392°F / 200°C) is not changed, within 2 seconds, the display changes
from the set temperature (with point ) to the actual temperature (without point ).
4. The griddle plate warms up to the set temperature.
5. As soon as the plate temperature reaches the set temperature value, turn the control knob to position 0
(OFF).
6. If the sensors detect enough residual heat, the display shows “HOT”.
If the display remains off, check:
• Is the induction unit connected to the power supply?
• Is the rotary switch set to the position ON?
• Is the RJ-45 cable connected from the operation unit to the generator?
For assistance, see chapter 10 Troubleshooting or call a Factory Authorized Service agency.