Garland MODUKB10000150 INDUCTION BUILT-IN MODULE-LINE GRIDDLE & BRAISING PAN - Manual (Page 19)

Installation RTCSmp Built-In Module-Line Griddle & Braising Pan
Part # 4532414 Rev 2 (1/15/14) 19
• A mounting frame for flush-mount installation is included with the module-line griddle plate. The frame
comes with a leveling plate and a silicone sealing gasket.
• The frame is to be mounted onto the underside of the counter surface.
• Installers are responsible for choosing the appropriate fasteners for the installation.
To flush mount a griddle plate:
IMPORTANT
To protect the induction unit from
water penetration, you must apply
and bond the silicone adhesive
properly to create a water-tight
seal. Before you begin the
installation, it is very important to
use isopropyl alcohol (minimum
70%) or equivalent to clean all
surfaces where the silicone
adhesive will be applied.
A. Countertop cut-out dimension: 671mm x 630mm [26.42” x 24.80”].
B. There are twelve (12) pre-drilled holes on the rim of the mounting frame. The frame is to be stud-
mounted. Secure it to the underside of the countertop.
C. Lower the griddle onto the mounting frame. The rim of the unit should sit on the leveling plate of the
mounting frame.
D. Level the griddle by adjusting the machine screws under the leveling plate. Note: Tilt the griddle slightly
to allow for easy drainage of grease/liquid towards the grease chute at the front.
E. Insert the Ø11mm heat resistant silicone gasket (provided) into the gap between the griddle plate and
the frame.
F. Apply silicone adhesive PACTAN (not provided, part# 70000015) completely around to seal the gap
between the griddle plate and the countertop.
NOTE: Allow the silicone to cure for at least 48 hours. Do not start up the griddle during this time.