9 instruction descriptions – INFICON TM-400 Thin Film Deposition Monitor User Manual
Page 71
10 - 5
IP
N 17
88
0
0 Re
v.
B
TM-350/400 Operating Manual
10.9 Instruction Descriptions
The following is a description of the valid instructions along with an example of how
they are used. All the examples assume the device address is 1.
1. Remote activation of monitor (Code #0)
This instruction initiates a key press of the TM-350/400’s keyboard. The valid key
codes are shown in
Format: Header, Instruction=1, Length=1, Key Code, Checksum Example:
Example of a remote start message:
Chr$(255)+Chr$(254)+Chr$(1)+Chr$(0)+Chr$(1)+Chr$(1)+Chr$(253)
2. Send monitor hardware configuration (Code #1)
Instructs the monitor to send monitor configuration data to the host computer.
is a description of the configuration data.
Example: To instruct the monitor to send the hardware configuration data the
computer would send:
Chr$(255)+Chr$(254)+Chr$(1)+Chr$(1)+Chr$(0)+Chr$(254)
Table 10-3 Remote Activation Code
Remote Activation Code
Description
1 Start
key
2 Stop
key
4 Shutter
key
8 Display
key
16 Film
key
32
Sensor Swap key
64
Simulate mode on
128
Simulate mode off
Table 10-4 Configuration Data
Name
Length (bytes)
Message
Software Version
35
TM-350 Software Version X.XX
Communication Port
1
(1=RS232, 2=RS-485, 3=IEEE488)
Total 36 bytes