JULABO LH 85 High Dynamic Temperature System - Manual (Page 36)

Manual operation
36
7.2. Direct setting of the working temperature
Setp.: 20.00°C
IntAct 21.00°C
ExtAct: --.--°C
Control: Intern
This setting may be carried out with the temperature system being
in operating state Start or Stop!
 The value previously set appears on the DIALOG-DISPLAY
(LCD) (example: 20.00 °C).
A flashing segment indicates that a value needs to be entered.
 Use the keypad to enter the new value and press enter
to store the selected value.
(examples: 120.00 °C; 228.50 °C; -15.00 °C).
7.3. Settings in the SET menu
 Press the key
to call up the SET menu. It is then
indicated on the DIALOG-DISPLAY (LCD).
Set the following values:
in Line 1: the working temperature in °C
Setp.:
Line 2: the high temperature limit in °C Overt.:
Line 3: the low temperature limit in °C Subtmp:
Line 4: the pump pressure stage St.Pump:
 Enter the desired values via the keypad. Settings may be
carried out with the temperature system being in operating
state Start or Stop!
 Use the cursors
to swap the lines.
 Press
escape to quit the SET menu.
7.3.1. Setting the working temperature
>Setp.: 200.00°C
Overt.: 255.00°C
Suptmp: -55.00°C
St.Pump: 2
>Setp.: 120.00°C
Overt.:255.00°C
Subtmp:-55.00°C
St.Pump: 2
>Setp: Setting the working temperature

Setting in line 1.
The value previously set appears on the DIALOG-DISPLAY
(LCD) (example: 100.00 °C).
A flashing segment indicates that a value needs to be
entered.

Use the keypad to enter the new value
(examples: 120.00 °C; 228.50 °C; -15.00 °C).

Press enter to store the selected value.