JULABO LH 85 High Dynamic Temperature System - Manual (Page 68)

Remote control
68
11.3. List of commands
When the RS485 interface is used, the instrument address stands in front of each command (Axxx_).
in commands: Asking for parameters or temperature values to be displayed.
Command Parameter Response of instrument
version none Number of software version (V X.xx)
status none Status message, error message (see page 71)
in_pv_00 none Actual bath temperature.
in_pv_01 none Heating power being used (%).
in_pv_02 none Temperature value registered by the external Pt100 sensor.
in_pv_03 none Temperature value registered by the safety sensor. >TANK<
in_pv_05 none Pump pressure in bar.
in_sp_00 none Working temperature
in_sp_03 none
High temperature warning limit
in_sp_04 none
Low temperature warning limit .
in_sp_05 none Setpoint temperature of the external programmer
(socket 3.1 - REG+E-PROG) .
in_sp_07 none Pump pressure stage
in_hil_00 none Max. cooling power (%).
in_hil_01 none Max. heating power (%).
in_mode_02 none Identification type:
0 = no identification
1 = single identification
2 = continual identification
in_mode_03 none Type of the programmer input:
0 = Voltage 0 V to 10 V
1 = Current 0 mA to 20 mA
in_mode_04 none Internal/external temperature control:
0 = Temperature control with internal sensor.
1 = Temperature control with external Pt100 sensor.