JULABO LH 85 High Dynamic Temperature System - Manual (Page 69)

69
Command Parameter Response of instrument
in_mode_05 none Temperature system in Stop/Start condition:
0 = Stop
1 = Start
in_mode_08 none Adjusted control dynamics
0 = aperiodic
1 = standard
in_par_01 none Time constant of the external bath.
in_par_02 none Internal slope.
in_par_03 none Time constant of the internal bath.
in_par_04 none Band limiting (max. difference between the temperatures in the
internal bath and external system).
in_par_06 none Xp control parameter of the internal controller.
in_par_07 none Tn control parameter of the internal controller.
in_par_08 none Tv control parameter of the internal controller.
in_par_09 none Xp control parameter of the cascade controller.
in_par_10 none Proportional portion of the cascade controller.
in_par_11 none Tn control parameter of the cascade controller.
in_par_12 none Tv control parameter of the cascade controller.
in_par_13 none Adjusted maximum internal temperature of the cascade controller.
in_par_14 none Adjusted minimum internal temperature of the cascade controller.
out commands: Setting parameters or temperature values.
Command Parameter Response of instrument
out_mode_01 0 Use working temperature
out_mode_02 0 No identification.
Temperature control by using the stored parameters.
out_mode_02 1 Single identification of controlled system after the next start.
out_mode_02 2 Continual identification of controlled system whenever a new
setpoint is to be reached.