JULABO LH 85 High Dynamic Temperature System - Manual (Page 66)

Remote control
66
Connector for removable control module RD (3.6)
Extension cable for operating device RD:
Order No. 8 980 126
2 m long
Order No. 8 980 127 5 m long
Control connector (10)
Output voltage is applied when the unit runs,
for example after pressing the start/stop key .
Output voltage: 230 V
 / max. 0.1 A
11. Remote control
11.1. Setup for remote control
9 6
5 1
RS232
RS485
Select the "Configuration" submenu and select the option "Setpoint" to
define the interface (see page 43).
The interface parameters are set by selecting the submenu "Interface"
on the instrument. Normally, this is a one-time-only adjustment.
(Selecting and setting menu items, see page 56.)
Factory settings:
RS232
BAUDRATE 4800 bauds
PARITY even parity
HANDSHAKE Protocol RTS/CTS
(hardware handshake)
Data bits 7
Stop bit 1
Like all parameters which can be entered through the keypad,
interface parameters are stored in memory even after the
instrument is turned off.