JULABO LH 85 High Dynamic Temperature System - Manual (Page 70)

Remote control
70
Command Parameter Response of instrument
out_mode_04 0 Temperature control of internal bath.
out_mode_04 1 External control with Pt100 sensor.
out_mode_05 0 Stop the unit = R –OFF-.
out_mode_05 1 Start the unit.
out_mode_08 0 Set the control dynamics - aperiodic
out_mode_08 1 Set the control dynamics - standard
out_sp_00 xxx.x Set working temperature.
out_sp_03 xxx.x
Set high temperature warning limit .
out_sp_04 xxx.x
Set low temperature warning limit .
out_sp_07 x Set the pump pressure stage (1 ... 5).
out_hil_00 -xxx Set the desired maximum cooling power (0 % to 100 %).
Note: Enter the value with a preceding negative sign!
out_hil_01 xxx Set the desired maximum heating power (10 % to 100 %).
out_par_04 xxx Band limiting during external control.
Setting the maximum difference between the temperatures
in the internal bath and external system.
out_par_06 xxx Xp control parameter of the internal controller.
out_par_07 xxx Tn control parameter of the internal controller.
out_par_08 xxx Tv control parameter of the internal controller.
out_par_09 xxx Xp control parameter of the cascade controller.
out_par_10 xxx Proportional portion of the cascade controller.
out_par_11 xxx Tn control parameter of the cascade controller.
out_par_12 xxx Tv control parameter of the cascade controller.
out _par_13 xxx Maximum internal temperature of the cascade controller.
out _par_14 xxx Minimum internal temperature of the cascade controller.