JULABO HT30-M1 High Temperature Circulator - Manual (Page 44)

Menu functions
44
8.3. Start of a profile
Configuration
>Identif. off
Setpoint keyb
Autostart on
1.
2.
The start menu of the High Temperature Circulator allows calling up and
defined starting of one of six previously stored temperature profiles. This
start can be effected manually or be released by an integrated timer.
Important:
In the menu configuration under menu point „setpoint“ operation has to
be set via „key“.
There are two possibilities for manually starting a program:
1. Starting a program from the OFF status:
The programmer switches back to the OFF status at the end of the
program.
2. Starting a program from the operating status.
The programmer is started with the Start key , and the bath is
heated to the desired temperature, for example 100 °C. At the end of
the program, the programmer switches to the operating status and
holds the bath temperature stable at 100.00 °C.
Configuration
Control param.
Profile Start
Int.Programmer
Inputs/Outputs
Limits
Interface
Temp.Sensor
Start Profile 0
at Step 0
Loops 1
>Start time
>hour.min 06:00
Day.Mon 15:11
Year 2000
Start yes
• Press enter
to select the submenu „Profile Start“.
• Use the up/down cursor keys
to select the desired
option.
A flashing segment indicates that a number needs to be entered.
Start Profile
0 to 5
at Step 0 to 60
Loops 1 to 99
Enter the desired number and set each entry with enter .
Start
no / yes  (m a n u a l s t a r t )
or
time  (via integrated timer)
A flashing line indicates that a parameter needs to be entered.
Press the P-key to select the respective parameter and press
enter .