JUMO 705010 mTRON T - Multichannel Controller Module Operating Manual - Manual (Page 135)

135
9 Online parameters
9.1.6 LED test
Setup dialog
Parameters
Parameter Selection/settings Description
P LED To test the LED, click the required status
to select it (OFF, green, or blue).
After selection, the LED enters the cho-
sen status immediately.
This function is used to test the electrical
function of the "P" LED (Power).
S LED To test the LED, click the required status
to select it (OFF, red, or green).
After selection, the LED enters the cho-
sen status immediately.
This function is used to test the electrical
function of the "S" LED (Status).
1 to 10 To test the LED, click the required status
(OFF or yellow) to select it.
After selection, the LED enters the cho-
sen status immediately.
This function is used to test the electrical
function of LEDs "1" to "10".
TIP!
An LED maintains the set status until a new status is set or until the "LED test" dialog window
is closed.