JUMO 705010 mTRON T - Multichannel Controller Module Operating Manual - Manual (Page 72)

6 Configuration
72
6.9.2 Controller input
This menu is used to configure the input signals of the controller – incl. the signals for switching
off the controller and for parameter block changeover – and the parameters for manual mode.
Setup dialog
Parameters
Parameter Selection/settings Description
Actual value Analog selector (Inactive) Analog signal as process value
Filter time con-
stant 0 s to 0.6 s to 100 s Time constant for adjusting the digital
input filter (0 s = filter off)
Parameter is only relevant for external
actual value (NV_...).
Decimal place x Decimal places of actual value (x)
Auto Automatic
XXXXX. No decimal places
XXXX.X One decimal place
XXX.XX Two decimal places
XX.XXX Three decimal places
X.XXXX Four decimal places
Setpoint Analog selector (Inactive) Analog signal as controller setpoint
value
Decimal place w Decimal places of setpoint value (w)
(Selection options as for Decimal place
x)
Outp. level feed-
back Analog selector (Inactive) Analog signal as output level feedback
?