Lenze PROFIBU PC-based Automation - Manual (Page 16)

Control technology | PROFIBUS communication manual
The Lenze control system with PROFIBUS
Brief description of PROFIBUS
16
L
DMS 2.2 EN 07/2011 TD17
Parameter setting
The PROFIBUS stations can be parameterised in different ways:
 Direct access of the engineering software (from the engineering PC) to the slave field
device. Depending on the device type, via the following interfaces:
– CAN
– Ethernet
– LECOM
– Diagnostic interface
 Parameter transfer from the control (the parameter transfer must be programmed
manually)
– PROFIBUS is exclusively configured with the »PLC Designer«:
Structure of the control configuration and creation of the PLC program
– All PROFIBUS slaves can be switched on via device data base files (GSE files).

Note!
The "IPC as gateway" function is not available in connection with PROFIBUS.
Thus, "Going online" with the »Engineer« or the »GDC« via the IPC as gateway is
not possible.