Lenze PROFIBU PC-based Automation - Manual (Page 5)

DMS 2.2 EN 07/2011 TD17
L
5
Control technology | PROFIBUS communication manual
About this documentation
1 About this documentation
This documentation ...
 contains detailed information on how to commission, configure, and diagnose the
PROFIBUS bus system within the Lenze control technology.
 belongs to the "PC-based Automation" manual collection which consists of the
following documentation:
Documentation Subject
System manuals
"PC-based automation"
• Control technology - System structure & configuration
• Control technology - System structure & components
Communication manuals
"PC-based automation"
• CANopen control technology
• PROFIBUS control technology
• EtherCAT control technology
(Software) Manual
"PC-based automation"
• Industrial PC - Parameter setting & configuration
Operating Instructions
"Embedded Line Panel PC"
• EL x8xx - built-in panel PC with TFT display
Operating Instructions
"Command Station"
• CS x8xx - stand-alone operator terminal
Operating Instructions
"Control Cabinet PC"
• CPC x8xx - control cabinet PC
Operating Instructions
"HMI EL 100"
• EL 1xx - HMI with Windows
®
CE
Further software manuals • »Global Drive Control« (»GDC«)
–IPC as gateway - Parameter setting & configuration
• »Engineer«
• »PLC Designer« / »PLC Designer - SoftMotion« / »PLC Designer - CANopen
for runtime systems«
• »VisiWinNET® Smart«