Lenze PROFIBU PC-based Automation - Manual (Page 25)

DMS 2.2 EN 07/2011 TD17
L
25
Control technology | PROFIBUS communication manual
Commissioning of PROFIBUS
Detailed commissioning steps
6.2.5 Commissioning of field devices
Parameterise the Lenze field devices connected to PROFIBUS either with the »Engineer« or
with »GDC«, depending on the device.
PROFIBUS is exclusively configured with the »PLC Designer«.

Tip!
We recommend to commission each field device individually and then integrate
them into the PLC program.
Servo Drives 9400 HighLine
During commissioning of a Servo Drive 9400 HighLine, the module parameter
DeactivateDPV1AutoSet must be set to the value "No":

Observe the information with regard to commissioning in the documentation
for the field devices.