Lenze DDS Function library Drive - Manual (Page 5)

Function library LenzeDrive.lib
Preface and general information
1.1 About this Manual
1−1
L
LenzeDrive.lib EN 1.7
1 Preface and general information
1.1 About this Manual
This Manual contains information on the function blocks that are included in the function library
LenzeDrive.lib for the Drive PLC Developer Studio.
·
These function blocks can be used in the 9300 Servo PLC, Drive PLC and ECSxA
automation system.
·
The function blocks are based on the functions that are available in the 9300 servo inverter
(V2.0).
In the Drive PLC Developer Studio (DDS) you make the basic settings for your drive application
offline by using variables (in accordance with the IEC61131−3 standard) as aids for parameterizing
the appropriate function blocks.
Via Global Drive Control (GDC) or the keypad you can then set the parameters for the required
functionality of your drive application online by accessing the codes of the function block instances.
1.1.1 Conventions used in this Manual
This Manual uses the following conventions to distinguish between different types of information:
Variable names
are written in italics in the explanation:
·
"The signal at nIn_a ..."
Lenze functions/function blocks
can be recognized by their names. They always begin with an "L_":
·
"The FB L_ARIT can ..."
Program listings
are written in "Courier", keywords are printed in bold:
·
"IF (ReturnValue < 0) THEN..."
Instances
For function blocks that have one or more first instances there are tables that describe the
corresponding codes:
Variable name L_ARIT1 L_ARIT2 Setting range Lenze
byFunction C0338 C0600 0 ... 5 1
You can access these codes online with Global Drive Control (GDC) or keypad.
Tip!
You can use the Parameter Manager to assign the same codes to these instances that are assigned
in the 9300 servo inverter (V2.0).