Lenze Drive Server Bus server S7 getting started - Manual (Page 9)

Busser
ver
S7
L
70
Bu
sse
rve
rS
7
DE/
EN
1.0
Communication
channel
PC interface PC interface
module
Transmission
medium
PLC interface module PLC interface Additional software required
IBHLink Ethernet - Ethernet IBHLink adaptor cable
Ethernet/MPI MPI IBHNet (V1.1 or higher)
COMxMPI COMx - RS-232 PC adapter RS-232/485 -
MPI Simatic USB - USB PC adapter USB Siemens communication driver
(V5 0
hi h )
S at c
COMx - RS-232 PC adapter RS-232/485
S e e s co u cat o d e
(V5.0 or higher)
PCI Siemens CP5611 MPI -
PCMCIA Siemens CP5511
Modem Teleservice Siemens
Teleservice adapter + Siemens teleservice
(V5.0 or higher)
Ethernet - Ethernet IBHLink adaptor cable
Ethernet/MPI + IBHNet (V1.1 or higher)
PROFIBUS DP COMx - RS-232 PC adapter RS-232/485 PROFIBUS-CP Siemens communication driver
(V5 0
hi h )
O US
USB - USB PC adapter USB
O US C S e e s co u cat o d e
(V5.0 or higher)
PCI Siemens CP5611 PROFIBUS -
PCMCIA Siemens CP5511
SOFTNET TCP/H1 Ethernet - Ethernet TCP/H1 - Ethernet-CP Siemens SOFTNET/SIMATICNET
(V3.0 or higher)
TCP direct Ethernet TCP -
Notes
COMxMPI
”x” stands for the number of the COM port.
Use ”MPI Simatic” as communication channel if the Siemens communication driver (V5.0 or higher) is installed on your PC or simultaneous access with
Lenze and Siemens software is required.
SOFTNET TCP/H1 Under normal circumstances, the TCP protocol is used. When using older CPs it may happen that only the Siemens H1 protocol is supported. This is why
the bus server S7 also supports the H1 protocol.
TCP direct If the corresponding Siemens software is installed on your PC, we recommend to use ”SOFTNET TCP/H1” as communication channel. Also use ”SOFTNET
TCP/H1” as communication channel if simultaneous access with Lenze and Siemens software is required.
Show/Hide Bookmarks