Lenze SO30 8400 protec - Manual (Page 55)

Safety option 30
Safe parameter setting
Parameter setting
5
l
55 EDS84DPSO01 EN 2.1
5.7.1.1 Parameter setting with the Lenze »Engineer« PC software
Safe parameter setting is supported by the Lenze »Engineer« PC software as of
version 2.10.
The parameter setting is described in the software manual of drive−based safety for 8400
protec controllers. In addition, the software provides comprehensive online help.
Password
To store a safe parameter set, a password is required. The standard password is: "Lenze
SM301". The password can be changed and must have at least six characters.
Use "General reset" to delete the safe parameter set in the memory module and the
drive−based safety. The drive−based safety must be reparameterised.
The password is reset to the standard "Lenze SM301".