MacDon A40-D Pull-Type - Manual (Page 109)

SECTION 7 MAINTENANCE AND SERVICING
169000
107
Revision F
A30-D Headers (Cont’d)
CROSS SHAFT BEARING (1 PLC)
NOTE
To prevent binding and/or
excessive wear caused by knife
pressing on guards, do NOT
over-grease. If more than 6 to 8
pumps of grease gun are required
to fill the cavity, replace the seal in
the knife head.
AUGER SHAFT BEARING (1 PLC)
REEL SHAFT BEARING (1 PLC)
High Temperature Extreme Pressure
(EP2) Performance With 1% Max
Molybdenum Disulphide
(NLGI Grade 2) Lithium Base.
A30-D HEADER LH SIDE
KNIFE HEAD BEARING (1 PLC)