Warning – MacDon A40-D Pull-Type User Manual

Page 152

Advertising
background image

SECTION 7 MAINTENANCE AND SERVICING

169000

150

Revision F

7.11.5.2 Replacing Stripper Bar

WARNING

To avoid bodily injury or death from
unexpected start-up or fall of raised
machine, stop engine, remove key, and
engage lift cylinder stops before going

under machine.

a. Remove four nuts and bolts (A) that secure each

stripper bar (B) (LH and RH) to the pan, and
remove bars. There are six bars in total.

b. Position new bars (B) on pan as shown, with

upper flange on front bar facing forward.

c. Install three bolts and nuts (A) in each bar, and

torque to 150 ft·lbf (203 N·m).

d.

Check clearance between auger and

stripper bars.

e. Loosen bolts (A), and add shims between

stripper bars and pan at bolt locations as
required to obtain clearance as shown.

f.

Retighten bolts to specified torque.

7.11.5.3 Front Stripper Bar Extensions

Extensions for the front stripper bar are provided
for installation (if required for certain crop
conditions), or especially in tall crops that cause
material to bunch up at the ends of the
conditioner rolls.

Stripper bar extensions will allow the auger to
carry the crop more towards the center, rather
than prematurely feeding it to the conditioner.

a. Raise header, and engage lift cylinder stops.

b. Remove nuts and carriage bolts (C) securing the

two extensions (D) to underside of header pan
support, and retain for reinstallation.

c. Position extension (D) at inboard end of front

stripper bars (E), and mark locations of the two
holes onto the plastic pan.

d. Drill two 5/16 in. (8 mm) holes at these locations.

e. Install extension with carriage bolts (C) removed

at sub-step b.

f.

Repeat above steps for other extension.

7.12 AUGER AND AUGER DRIVE:

A40-D

The A40-D header auger is driven directly from
a hydraulic motor, and there are no belts or
chains to maintain.

For auger and stripper bar maintenance
procedures, refer to Section 7.11.3 Auger Pans,
Section 7.11.4 Rubber Fingers, and Section
7.11.5 Stripper Bars.

D

C

LH SIDE

(AUGER NOT SHOWN FOR CLARITY)

D

E

C

FWD

B

A

Advertising
This manual is related to the following products: