MacDon A40-D Pull-Type - Manual (Page 154)

SECTION 7 MAINTENANCE AND SERVICING
169000
152
Revision F
7.13.3 Disassembling Forming Shield
a. Invert forming shield onto top.
b. Remove lynch pin (A) from adjuster rods (B),
and disassemble rods from side deflectors (C).
c. Disassemble nut (D) from bolt (E), and lift
deflector (F) and washer (G) off forming shield.
Repeat for other deflector.
d. Disassemble locking handles (H), and
remove bolts.
e. Disassemble fluffer shield (J) from forming
shield cover.
f. Remove bolts (K) to remove deflector fins (L)
from cover.
7.13.4 Assembling Forming Shield
Reverse the procedure in Section 7.13.3
Disassembling Forming Shield.
7.13.5 Installing Forming Shield
a. Remove two clevis pins (M) from forming shield
forward end.
b. Position forming shield under the
windrower frame.
(continued next page)
A
B
C
K
L
H
H
J
M
E
D
G
F