MacDon A40-D Pull-Type - Manual (Page 45)

SECTION 6 OPERATION
169000
43
Revision F
m. If valve blocks are NOT configured (as shown),
install required fittings as described in A40-D
Auger Self-Propelled Windrower Header
Unloading and Assembly Instructions – MD Part
#169078 that was supplied with your
A40-D header.
n. Push auger/reel pressure (A) and auger/reel
return (B) hose couplers onto mating
receptacles on valve block, until collar on
receptacle snaps into lock position.
o. Open header LH driveshield.
p. Check hose routing at the reel motor. The hose
routing depends on which windrower model the
header is being attached to. The header is
factory-configured for M150, M155, and
M200 windrowers.
q. Change hoses as follows if header is being
mounted on a M100, M105, or M205 windrower:
1. Disconnect hose (C) at tee (E).
2. Disconnect hose (D) at reel motor.
3. Disconnect tee (E) at motor lower port and
relocate to upper port.
4. Connect hose (D) to tee (E).
5. Connect hose (C) to motor lower port.
B
A
B
A
FACTORY CONFIGURATION
M150, M155, AND M200
C
D
E
M100, M105, AND M205
C
D
E