MacDon A40-D Pull-Type User Manual

Page 66

Advertising
background image

SECTION 6 OPERATION

169000

64

Revision F

6.15.2 Left Side Operation: Pull-Type

Move steering lever backward to achieve
desired position of mower conditioner on LH
side of tractor.

To adjust tracking of mower conditioner during
LH side operation, the steering cylinder stroke
control can be re-positioned:

a. Loosen clamping bolt (A) on stroke control (B),

and rotate stroke control to desired position.

Each turn of the stroke control changes the
tracking by approximately 2 in. (50 mm).

DESIRED

TRACK

CYLINDER

STROKE

STROKE CONTROL

POSITION

Further LEFT

Decrease

Rotate Stroke Control (B)

Away From Clevis.

Further RIGHT

Increase

Rotate Stroke Control (B)

Towards Clevis.

b. Tighten clamping bolt to 65 ft·lbf (90 N·m).

c. Re-check torque on clamping bolt after 1 hour,

and every 100 hours thereafter.

IMPORTANT

The adjustment for right side operation
must be done PRIOR to adjustment for LH
side operation.

6.15.3 Avoiding Obstacles

Move steering lever as required to

avoid obstacles.

6.15.4 Square Corners

The following procedure is intended only as a
guide to developing a turning procedure for the
tractor being used. Specific distances are NOT
given due to the variances in

tractor manoeuvrability.

a. As tractor approaches the corner, guide tractor

sharply away from the crop. Steer the mower
conditioner to maintain a straight cut ahead, as
the tractor moves away from the crop.

b. As soon as the knife cuts past where the new

corner will be, raise the header sufficiently for
skid shoes to clear the ground, then steer the
mower conditioner to the extreme direction away
from the uncut crop.

c. As the tractor passes the corner, steer it sharply

back towards the uncut crop, taking care that the
inside tractor tire does not contact the mower
conditioner Articulating Power Tongue (APT).

d. Guide the tractor to straddle the last cut

windrow. As the mower conditioner finishes
turning, steer it back towards the uncut crop,
align the header with the crop edge, and lower
header to cutting height.

A

B

Advertising
This manual is related to the following products: